DESCRIPTION
Polyprimer EP is two component, solvent free, low viscosity epoxy primer and sealer. It is supplied in two components Resin (A) and Curing Agent (B) when mixed and applied will provide an excellent penetration on porous substrate with high adhesion to concrete and steel.
ADVANTAGES
- Easily applied by brush or roller.
- Long open time.
- High wetting out characteristics.
COVERAGE
Approximately 0.2-0.3 kg /m 2 .
VOLUME SOLIDS
100%
OPEN TIME
24 hours after curing
INSTRUCTION FOR USE
It is essential that Polyprimer EP be a sound clean and dry surface in order to achieve maximum bond strength between substrate and coating, flooring or repair products.
Concrete substrates
Should be at least 28 days old. Laitance deposits on new concrete are best removed by light grit–blasting, mechanical scrabbling or grinding. On small areas, thorough acid-etching using Acid Etch may be considered. After etching, the substrate shall be thoroughly washed with clean water and then allowed to dry. Where heavy contamination by oil and grease has occurred or existing coating are present, it is essential that all contamination are removed.
MIXING
Pour the component B (Hardener) into the component A (Base) and mix from 2-3 minutes until uniform consistency is achieved.
Do not mix partially
APPLICATION
Apply the mixed material to the prepared surface using brush or short haired quality wool roller. Avoid primer pounding on the floor to reduce exothermic effect, which will reduce the pot life
CLEANING
Clean all tools and equipment immediately after use with any solvent.
PRECAUTIONS
Health and Safety
Some people are sensitive to epoxy resins, so gloves and a barrier cream shall be used when handling these products.
If contact with the occurs, if must be removed, before if hardens, with resin removing follow washing with soap and water.
FIRE
Polyprimer EP and Solvents are flammable. Ensure adequate ventilation. Do not smoke or use near naked flame
FLASH POINTS
Polyprimer EP 100 0 C
STORAGE
Polyprimer 31 has a shelf life of 12 months stored in dry &cool place below 25 0C
SUPPLY
Contact your local POLYCOO office or representative.