1)    Surface preparation:

• Surface must be clean, free from oil, grease, dirt and chalk... etc.

• Old painted surfaces should be cleaned from loose paint and other materials that can affect adhesion


2)    Recommended Application System:

Use POLY SEAL PRIMER as a primer coat before applying putty. Additional coat after applying putty helps improving adhesion and spreading rate. 

Use POLY ACRY PUTTY / POLY UNOSHIELD PUTTY for smoothening and leveling the surface

·  Mix POLY ROYALE COAT thoroughly to uniform consistency before use.

·  It is recommended to dilute with water not exceeding 10% for ease of application depending on climatic condition.

·  Allow 6 hours of drying between each coat.



Alternative systems may be specified, depending on area of use.

Please refer to technical office for application advice



Roller, Brush, Spray Gun.



10-13.5 m2 / Ltr. per coat at 30 - 40 microns DFT.  Practical coverage varies depending on surface porosity, application method, DFT and losses.


Refer to company price list or contact the local representative



36 months in original tightly closed containers away from direct sunlight and excessive heat.


'Teflon is a registered trademark of The Chemours Company FC, LLC

used under sublicense by Soib Chemical S. A. E "For exterior use please refer to the exterior colour chart.

'Refer to Material Safety Data Sheet (MSDS ) before using the product.

Our Recommendations are based on extensive research as well as practical experience. However, as the product is often used under conditions beyond our control, we cannot guarantee anything but the quality of the product itself. We reserve the right to change the given data without notice. Please note that this data sheet supersedes any previous prints. For any additional information, please consult our technical office    .May/2015


Quick Overview: